My newly completed bench in my newly completed workshop. I couldn't be happier with the results, and Richards instruction and style helped a ton. A few years ago I wanted to get away from power tools, so I sold off what I could do without and started buying old stuff off eBay and restoring it. Finally got to the point that I had a room in the basement I could use for a workshop. After getting that all squared away, it was time for the workbench build. My first hand tool only project. Being able to build this bench without already having a bench was likely it's biggest selling point for me....no big laminations and such. But it also has a traditional beauty that I don't think can be denied. Since I couldn't get 8/4 pine here....we'll, I could, but the price rivaled beech and pacific coast maple. So I went to the home center and bought green doug fir construction lumber. Mostly 4x8, but also 4x6 for the legs, and some 2x boards for the trestles and bearers. The top three boards finished out about 3 1/8" thick, and I took the front apron down to around 2 1/2". While I'd have loved to go the wooden vise screw route, I was a bit worried about clamping narrow boards against the top, pulling on the apron. So I went with a twin screw, chain drive vise that attaches to the underside of the top. Works great, but was unfortunately more expensive than all the rest of the bench materials combined. The process of building it was great too. I learned a lot, and with so many trips to the sharpening stones, finally know what truly sharp is. Thanks for those videos as well! I've rambled on long enough. I simply can't thank Helen and Richard enough for putting out such great content in a way that's instructional, informative, and entertaining. Cheers to you both!