This was the toughest joint so far and I well and truly made a meal of it. Everything was going great until I had to free-hand saw the dovetail shoulder on that 45-degree angle. I went and cut it about 47-degree. I could see as soon as I started the cut that I was going off the line. I ploughed on thinking I might as well make it a neat cut even if it is at the wrong angle. I decided I would fix it by changing the angle of the whole joint as I'd not cut the leg bit yet. By this time I had bought a shoulder plane and that came in very handy. So now when I come to cut the apron joint for the brace, It won't be 45 degrees - I'll worry about that later! I was all happy with my bodge until a little bit of the shoulder then chipped off. That rounded off a bad day!